Magnum 257065 Spécifications télécharger pdf (Page 27)

Control Board Diagnostics (ProLTS 17 and ProLTS 19)

313036L 27

Control Board Diagnostics (ProLTS 17 and ProLTS 19)

NOTE: Check for motor problems before replacing control board. A damaged motor may burn out a good control

card.

Check for a damaged control board or pressure control

switch as follows:

1. Relieve Pressure, page 11.

2. Unplug electrical cord.

3. Remove four cover screws and front cover.

Remove motor enclosure.

4. Remove yoke and guide rods.

5. Remove gear.

6. Remove pressure control harness from control

board. Using tip of small, flat blade screwdriver,

press tab on right side connector to release.

7. Attach harness from a pressure control switch you

know is functioning correctly to control board.

NOTE: Pressure control switch does not have to be

installed in pump.

8. Turn pressure control adjustment knob (C) +to max-

imum pressure setting.

9. Plug electrical cord into 120VAC receptacle.

10. Turn power switch (B) ON.

• If motor runs, replace pressure switch.

Pressure Control Switch Kit, page 28.

• If motor does not run, replace control board

repeat test. Control Board Kit, page 28.

Control Board Diagnostics (LTS 15 and LTS 17)

NOTE: Check for motor problems before replacing control board. A damaged motor may burn out a good control

card.

1. Unplug electrical cord and Relieve Pressure,

page 11.

2. Remove enclosure and check all control board con-

nectors for proper installation (see Wiring Diagram,

page 49).

3. Check fuse on control board. If fuse is blown, deter-

mine the cause before replacing control board (see

Advanced Troubleshooting, page 18).

Pump Diagnostics

When pump packings wear, paint begins to leak down

the outside of the pump. At the first sign of leakage,

replace the pump or additional damage to the drive train

could occur.

1. LTS 15 and LTS 17: Replace pump using Pump

Replacement (Complete). See List of Kits,

page 28.

ProLTS 17 and ProLTS 19: Replace pump using

Pump Repair kit. See List of Kits, page 28.

2. If there is no paint leakage, see Advanced Trouble-

shooting, page 18. Pump may not be defective.

NOTICE

When repairing or cleaning the pump, never submerge

pump in water or allow fluid to enter pressure control.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

Magnum 257065 Spécifications Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Outils de jardin Magnum 257065